Card Cage; Remove The Card Cage - Christie CP2215 Service Manual

4. Remove the exhaust panel and rear projector skins. See
page 26 and Remove the Rear Skin on page
5. Remove the 2 screws that secure the AC line filter to the bracket.
6. Disconnect the 2 harnesses from the 220V AC line filter.

Card Cage

Only Christie authorized service technicians should open the high security lid or access the
electronics inside the card cage.

Remove the Card Cage

The card cage module consists of the PIB, PIB faceplate board, ICP and backplane.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the high security lid. See
5. Reach into the top of the projector and disconnect the LEQD:
a. Loosen the thumbscrew on the top the LEQD.
b. Pull the two LEQD ejector latches outward.
c. Pull the LEQD and cables up and place them on the top of the light engine compartment.
6. Disconnect the 6 backplane connectors (P10, P8, P11, P9, P14).
7. Reach into the projector and pull the lever to release the security ring.
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)
26.
Remove the Top Lid on page 22.
Remove the High Security and Light Engine Lid
Parts and Module Replacement
Remove the Exhaust Panel Skin on
on page 24.
41