Remove The Safety Shield - Christie CP2215 Service Manual

2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the front skin. See
5. Remove the service door. See
6. Loosen the 3 screws from the bottom of the exhaust panel skin.
7. Remove the 4 screws that secure the skin to the corner brackets.
8. Pull the skin forward and out.

Remove the Safety Shield

EXPLOSION HAZARD! Wear Christie approved protective clothing (598900-95) when the
safety shield is open and handling the lamp. Failure to comply results in death or serious
injury.
The safety shield is positioned above the lamp reflector and is used to block UV light.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Loosen the 2 captive screws.
5. Pull the safety shield up and outward from the locking tabs.
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)
Remove the Top Lid on page 22.
Remove the Front Skin
Remove the Exhaust Panel Skin
Remove the Top Lid on page 22.
Parts and Module Replacement
on page 22.
on page 26.
27