Table of Contents
Advertisement
Function-Group Types
5.7 Function-Group Type Analog Units
Parameter: Temperature unit
To change the display and evaluation of measured temperature values from °C to °F, adapt the DIGSI user
default settings accordingly.
Proceed as follows:
•
In DIGSI select the menu item Extras --> Settings.
•
In the Settings view select the menu item DIGSI 5 User preferences.
•
Under Standard unit system change the setting value of the unit system used from
units .
[scfahrht-190214-01, 1, en_US]
Figure 5-80
The following settings and information table shows only 1 of the 12 sensors, as the setting possibilities of the
12 sensors do not differ.
5.7.7.7
Settings
Addr.
General
_:2311:103
Sensor 1
_:11611:102
5.7.7.8
Information List
No.
General
_:2311:53
_:2311:56
282
Change of the Display Between °C and °F
Parameter
General:Port
Sensor 1:Sensor type
Information
General:Health
General:Failure
C
Setting Options
•
port E
•
port F
•
port J
•
port N
•
port P
•
Pt 100
•
Ni 100
•
Ni 120
SIPROTEC 5, High-Voltage Bay Controller, Manual
SI units to US
Default Setting
port J
Pt 100
Data Class
Type
(Type)
ENS
O
SPS
O
C53000-G5040-C015-9, Edition 11.2017
Advertisement
Table of Contents
