Setting Simotion C To Factory Settings - Siemens SIMOTION Operating Instructions Manual

Commissioning
8.6 Deleting data
8.6.4

Setting SIMOTION C to factory settings

Overview
SIMOTION C is supplied with preset parameters, such as the transmission rate or PROFIBUS
addresses. You can restore the factory settings with the mode selector. The following data is
deleted during this operation:
● "Non-volatile data" in the SIMOTION device
● The backup (PMEMORY.XML/PMEMORY.BAK) of the non-volatile data on the MMC
● User data in the "volatile data" and on the MMC
● The communication configuration (IP and DP parameters) is set to the factory settings
The licenses on the micro memory card are retained.
Operations on the mode selector
Proceed as follows:
1. Switch off the power supply for SIMOTION C.
2. The micro memory card is inserted in the SIMOTION C.
3. Switch the mode selector to the MRES position. Keep this position selected and switch the
power supply for the SIMOTION C on. When the STOP LED display lights up statically,
switch the mode selector switch back to the STOP position.
Note
After switching on the power supply, it takes approx. one minute until the SIMOTION C
deletes the "permanent power off" data, performs a restart and has reached the STOP state.
Note
The communication configuration is now reset to the factory settings. The communication
configuration for the SIMOTION C must be repeated.
See also
Factory setting (Page 127)
150
Operating Instructions, 11/2016, A5E33441428B
SIMOTION C