Transfer Settings - Siemens LOGO! 24RC Manual

PC
STOP:
Press ESC
To switch LOGO! automatically to PC
ceed as follows:
1. Switch off the power supply to LOGO!
2. Remove the cover or the program module/card and
connect the cable there.
3. Switch the power back on.
LOGO! automatically goes into PC
The PC can now access LOGO!. You can find out how to
do this on the online help system of the LOGO! software.
You can interrupt the connection to the PC using ESC on
LOGO!.

7.3 Transfer Settings

To transfer programs between the PC and LOGO!, you
must make certain settings in the LOGO! software. You
can make these settings using the menu of the software
you are using.
LOGO!Soft Comfort
Specify which LOGO!: LOGO!Soft Comfort works out
which LOGO! variant you will need to use the written
program.
Options
which LOGO! is connected. You can also find out the
correct port automatically (each port is checked by the
program for a connected LOGO!).
Transfer: PC
you have created in LOGO!Soft Comfort to LOGO!.
Transfer: LOGO!
you have created in LOGO! to LOGO!Soft Comfort.
LOGO! Manual
A5E00067781 01
Interface: You can enter the serial port to
LOGO!: Use this to transfer a program
PC: Use this to transfer a program
LOGO! Software
= LOGO!
LOGO mode, pro-
LOGO mode.
149