MA lighting dot2 User Manual page 112

Figure 1: Choose store method.
There are four options here:
Merge
- This option will add the values to the existing values in the cue.
Remove
- This will remove the existing values of the same type that you currently have active in your programmer.
Overwrite
- This will delete the current content of the cue and add your active value to the cue.
Create Second Cue
- This option is only available when you have a cue list with only one cue. Pressing this will
add your currently active values to a new cue number 2.
If you want to store a specific cue number then you can use a more precise command input. E.g. you want to store
cue number 5. Then you can use the follow key presses:
while storing it. E.g. you want to store cue number 5 with a fade time of 3 seconds. To do this press the following
keys: Store Cue 5 Time
If you don't specify the cue timing when you store the cue, then it uses the default times set in the
window. You can set these by pressing the
Figure 2: Time defaults window.
If you want to store your cue on a different executor (not the main executor), the you need to press a key associated
with the executor. E.g. you want to store cue number 2 on a specific executor. Then you'll need to press the
following keys: Store Cue 2
cue.
Storing a cue will do an
removed. Please use the
© 2 0 1 5 MA L i g h t i n g T e c h n o l o g y G mb H - D a c h d e c k e r s t r . 1 6 - D - 9 7 2 9 7 Wa l d b ü t t e l b r u n n - G e r ma n y - w w w . ma l i g h t i n g . c o m
d o t 2 U s e r Ma n u a l
(= Fade command)
Time
and then press one of the keys associated with the executor where you want the
Auto Unblock
. This means that after you have stored a cue all unchanged values are
Protect
function (read below) if you want to "block" a cue.
Store Cue 5 Please
3 Please .
key (with an empty command line). It could look like this:
112
. You can even add a cue timing
Time Defaults