MA lighting dot2 User Manual page 113

The dot2 is a tracking console. If you don't know what this means please have a look at the
page.
Update a cue
You can always store your current active programmer content into any cue you want.
But if you have an active cue running, then you have the possibility to use the
you press Update Please
If you press Update followed by a key on one of the other executors, then you update the active cue on that
executor. If there isn't an active cue, then nothing happens.
Update will give you a windows asking how to update. There are two modes called
will do a tracking update and Cue only will preserve the values in the following cue.
Updating the cue will do an
removed. Please use the
Naming a cue
Right after you store a cue there's the Label pop-up. If you press this, then you are taken to the
window.
If you need to label a cue after it's created, then you can use the
in the main executor: Label Cue 2 Please
You can also open a Cues view
seconds, then you also get the Enter Name for window.
Change the cue timing
There are many different timings in a cue. They can be seen in the
The usual (In)Fade and Out Fade values set the times used respectively by the attributes going up in value and the
attributes going down in value. The factory default is that the Out Fade is set to the Fade (or InFade) time. So no
matter what you set the fade time to, then the OutFade will be the same. But you have the possibility to separate
them.
You can also set a delay for the OutFade. This is a time that the console will wait before beginning the OutFade.
All available Preset Types have their own timings for fade and delay. Setting this will overwrite the set cue timing for
the values changing in that Preset Type.
Default timing
You can press the Time
default when you create new cues.
Set a time when storing
You can overwrite the default timing when you store a cue. E.g. you want to store cue 3 with a fade time of 5
seconds: Store Cue 3 Time
© 2 0 1 5 MA L i g h t i n g T e c h n o l o g y G mb H - D a c h d e c k e r s t r . 1 6 - D - 9 7 2 9 7 Wa l d b ü t t e l b r u n n - G e r ma n y - w w w . ma l i g h t i n g . c o m
d o t 2 U s e r Ma n u a l
, then you update the active cue on the main executor.
Auto Unblock
. This means that after an update all stored, but unchanged values are
Protect
function (read below) if you want to "block" a cue.
.
and press in the cue name you want to change. If you keep pressing it for around 2
key to open the Time Defaults
(= Fade command)
Update
Label key. E.g. you want to label cue number 2
Cue view.
window. Here you can set the times that will be used as a
5 Please .
113
What is tracking
key. It's a faster work flow. If
Normal Cue Only
and . Normal
Enter Name for
help