Selection Command
8.56.
This page describes the syntax and how to use the Selection command.
To go to the Selection command, press and hold
Description
With the Selection command, you can deselect the current selection of fixtures.
The fixtures are removed from the programmer.
Syntax
Deselect the current selection of fixtures and remove them from the programmer.
Off Selection
Example
Let´s assume, you will deselect the current selection of fixtures and remove them from the programmer.
Figure 1: Selected fixtures in the programmer.
Figure 2: Deselected fixtures in the programmer.
Press
Off
+
Fixture
The current selection of fixtures is deselected.
8.57.
SetIP Command
This page describes the syntax and how to use the
To use the SetIP command, type
Description
© 2 0 1 5 MA L i g h t i n g T e c h n o l o g y G mb H - D a c h d e c k e r s t r . 1 6 - D - 9 7 2 9 7 Wa l d b ü t t e l b r u n n - G e r ma n y - w w w . ma l i g h t i n g . c o m
d o t 2 U s e r Ma n u a l
(= Selection)
Please
.
SetIP
SetIP
in the
command
and
Fixture
on the console.
command.
line.
432