MA lighting dot2 User Manual page 225

Tap at to select the direction mode of the chaser.
There are four directions modes available
Forward
Backward
Bounce (e.g. starts with cue 1 to 4 and goes back from 4 to 1)
Random
Endless
(chaser run mode):
Tap at to select the run mode of the chaser.
There are three run modes available.
Endless
Shoot-Off
The chaser starts at the selected cue, e.g cue 1, and stops at the end of cue 5. The executor is off after the last
cue.
Shoot-On
The chaser starts at the selected cue, e.g. cue 1, and stops at the end of cue 5. The executor is on after the last
cue.
Play:
Tap to start the chaser.
Pause:
Tap to set the chaser to pause.
Half Speed:
Tap to set the chaser to half of the current speed.
1:1 Speed:
Tap to set the speed to the adjusted speed. To adjust the speed, use the encoder.
Double Speed:
Tap to set the speed to the double of the entered speed.
Encoder Bar Functions
Figure 4: Encoder Bar Function on Screen 1 if Executor is a Chaser
Fade
(only available if the executor is a chaser):
With this encoder you set the fade percent from one cue to another cue.
The default is 0% and it goes up to 400%.
To set the fade percent without decimal places, turn the encoder left or right.
To set the fade percent with decimal places, press
is slow.
Speed
(only available if the executor is a chaser):
To set the speed of the chaser higher or lower, turn the encoder left or right.
© 2 0 1 5 MA L i g h t i n g T e c h n o l o g y G mb H - D a c h d e c k e r s t r . 1 6 - D - 9 7 2 9 7 Wa l d b ü t t e l b r u n n - G e r ma n y - w w w . ma l i g h t i n g . c o m
d o t 2 U s e r Ma n u a l
and then turn the encoder left or right. The encoder speed
225