Move Command - MA lighting dot2 User Manual

Syntax
1. Send MIDI Note with the selected MIDI channel from the
MidiNote 12
2. Send MIDI Note with defined MIDI channel and full velocity (127).
MidiNote 1.12
3. Send MIDI Note with the selected MIDI channel from the
MidiNote 12 60
4. Send a MIDINote Off.
MidiNote 14 Off
Example
Let´s assume, you will send a MIDI note on a specific cue to trigger a sound station.
Requirements:
Connected sound station device e.g. computer on the MIDI Out connector.
Stored cue on an executor.
Open the cues view and type in the CMD (= command) column the following syntax:
Figure 1: Cues View with MIDI Notes in the CMD column
The MIDI note will be send if the cue is executed and will trigger the connected sound station.
8.40.

Move Command

This page describes the syntax and how to use the move command.
To go to the move command, press
Description
© 2 0 1 5 MA L i g h t i n g T e c h n o l o g y G mb H - D a c h d e c k e r s t r . 1 6 - D - 9 7 2 9 7 Wa l d b ü t t e l b r u n n - G e r ma n y - w w w . ma l i g h t i n g . c o m
d o t 2 U s e r Ma n u a l
MIDI Show Control window
MIDI Show Control window
Move on the console.
407
and full velocity (127).
and a velocity of 60.
MidiNote 12