Preview Command - MA lighting dot2 User Manual

Preset Key
MA Key
Preset Type Bar
How to work with Presets?
8.50.

Preview Command

This page describes the syntax and how to use the preview command.
To go to the preview command, press
Preview is in the command
Description
With the Preview command you get a preview of the programmed output in the
without having an actual DMX output.
You can use the Preview command for preview
executors
cues
Hint:
If the console is in the preview mode, the
changes into red.
Hint:
To leave the preview mode, press
Syntax
1. To get a preview from an executor 102.
Preview ExecButton1 1.102
2. To get a preview from cue 1 on the main executor.
Preview Cue 1
Example 1
Let´s assume you will have a preview of the programmed executor 102 without having an actual DMX output.
There are five ways to do this:
a) Press Prvw and tap at executor 102 in the
© 2 0 1 5 MA L i g h t i n g T e c h n o l o g y G mb H - D a c h d e c k e r s t r . 1 6 - D - 9 7 2 9 7 Wa l d b ü t t e l b r u n n - G e r ma n y - w w w . ma l i g h t i n g . c o m
d o t 2 U s e r Ma n u a l
Prvw on the console.
line.
Prvw
Esc or
executor bar
key is blinking and the title bar of the fixtures sheet
Off Prvw on the console.
window.
423
fixtures view and in the dot2 3D,