MA lighting dot2 User Manual page 224

Figure 2: Cues View - No Timecode Source is turned on in the Timecode Configuration Window
To open the executor settings, tap the
To pin the view and deactivate the dynamic view mode, tap on the
Below the title bar is the cue table. In this table you can edit the
Number. The edit cue number(s) window
Cue Name
Protected
Trig (Trigger). The select trig window
Trigger Time
Fade
Out Fade
Out Delay
Preset Type Timings
Cmd (Command)
Snap Percent
To edit the cells of the cue table, press and hold the cell. The corresponding edit window opens.
A selected cell in the cue table has blue background with a white frame around.
The current executed cue in the cue table has a green background.
The blue bar in the name column of a running cue displays the fade time from 0% to 100%.
For more information about cues, refer to
If a cue is set to protected, a white line is displayed to see where the tracking stops. For more information, refer to
What is Tracking?
Chaser
If the executor is set to a chaser, all cue functions and timings which are not active in the chaser mode are shown
gray out. For more information about chasers, refer to
Additional is the chaser bar visible.
Figure 3: Chaser Bar in the Cues View
Forward
(chaser direction mode):
© 2 0 1 5 MA L i g h t i n g T e c h n o l o g y G mb H - D a c h d e c k e r s t r . 1 6 - D - 9 7 2 9 7 Wa l d b ü t t e l b r u n n - G e r ma n y - w w w . ma l i g h t i n g . c o m
d o t 2 U s e r Ma n u a l
tool
in the title bar. It opens the
opens.
opens.
What is a Cue? and How to work with
What is a Chaser?
224
settings of executor
pin
in the title bar.
Cues?.
and How to work with
window.
Chasers?.