MA lighting dot2 User Manual page 280

d o t 2 U s e r Ma n u a l
Art-Net and sACN are additional network protocols to the default network protocol dot2-Net.
The network protocols transports DMX with wired network connection (Ethernet).
The green tick displays, that this network protocol is enabled.
The red prohibition sign displays, that this network protocol is disabled.
To enable or disable a network protocol, tap at the network protocol type.
Below the network protocol is the IP address displayed from which the network protocol is sent.
The Art-Net IP address is visible after Art-Net is enabled and a session is active.
To change the IP address, use the SetIP command.
The following columns are available:
Active:
Displays if Art-Net or sACN is on or off for the respective universe.
To turn Art-Net or sACN on or off for the respective universe, tap and hold the cell or press the Scroll Active encoder.
Mode:
Displays the supported mode of the network protocol.
Art-Net = Output Broadcast (Art-Net 1)
sACN = Output Multicast
dot2 Universe:
Displays the dot2 universes from 1 to 8.
Art-Net universe / sACN universe:
Displays the Ethernet universe.
Art-Net = 0:0 - 0:7
sACN = 1 - 8
Encoder Bar Functions
Figure 2: Encoder Bar - Network Protocols Configuration Window
Network Protocol:
To select a network protocol, turn the encoder left or right.
To enable or disable a network protocol, press the encoder. The current status is displayed in brackets.
Scroll Active:
To scroll in the active column, turn the encoder left or right.
To select on or off in the active column, press the encoder.
Select Active:
To select multiple cell, press and turn the encoder left or right.
A blue frame around the cells displays the selected cell.
280
© 2 0 1 5 MA L i g h t i n g T e c h n o l o g y G mb H - D a c h d e c k e r s t r . 1 6 - D - 9 7 2 9 7 Wa l d b ü t t e l b r u n n - G e r ma n y - w w w . ma l i g h t i n g . c o m