Ventilation And Cooling; Replacing Fans 1, 2, And 3; Replacing Fans 4 And 10 - Christie GS Series Service Manual

Ventilation and cooling

Vents and louvers provide ventilation, both for intake and exhaust, keeping the projector
components within their operating temperature specifications.
Do not install the projector near a radiator, heat register, or within an enclosure. To ensure
adequate airflow, follow the requirements specified in the line drawing (P/N: 020-001122-XX) and
never block or cover the vents.
When replacing fans, ensure you confirm the fan direction for airflow. The correct orientation of the
fan also ensures that the fan harness reaches the connector.

Replacing fans 1, 2, and 3

To replace fans 1, 2, or 3 complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the right-side cover.
See Removing the right-side cover
3. To separate the affected fan from the right-side cover, remove the corresponding four M3
screws.
4. Replace the affected fan.
5. To re-install, follow these steps in reverse order.

Replacing fans 4 and 10

To replace fans 4 and 10 complete the following steps.
1. Remove all covers from the projector.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
on page 57.
on page 59.
64