Batteries - Replacement - Case WX145 Operator's Manual

BATTERIES - REPLACEMENT

S
WARNING
Shut off the engine before removing batteries, to
prevent damaging the alternator and regulator or
the electronic modules.
Disconnect clamps from poles in the correct
sequence.
A sequence error can cause a short-circuit.
Park the machine on a level and firm surface.
Set the ignition key to position "0" (start OFF).
Shut off the engine.
Place the machine in a safe condition.
Open the hood (1): is held open thanks to gas
springs (2).
Now batteries are accessible (3).
Unscrew the screws (5) and remove the locks (4).
Remove the cap (6).
Disconnect the clamp of the battery negative pole (-
).
Disconnect the clamp of the battery positive pole
(+).
Insulate the clamps.
Remove the batteries (3).
Before installing the new batteries, polish the con-
tact faces of the battery poles and clamps.
Install the new batteries (3).
Connect the clamp to the battery positive pole (+).
Connect the clamp to the battery negative pole (-).
Tighten the clamps screw firmly.
Avoid to overtighten the screws so as not to damage
them.
Finally apply grease or non-corrosive Vaseline to
the battery poles and clamps.
The presence of loosen or corroded clamps gener-
ates overloads on the generator and regulator.
Reassemble the cover (6) and the locks (4) and fas-
ten them with screws (5).
Close the hood (1).
S
Copyright ©
SUPPLIES AND SERVICE CHART
131
132
4-87