SECTION 1
PARKING THE MACHINE
Park machine on flat and firm surface.
Return the machine to basic position.
Lock the upper structure.
Place the attachment down on the ground.
Engage the parking brake.
Shut off the engine.
S
CAUTION
Do not shut off the engine when running at full
speed, but let it run idle for some minutes to cool it
down.
Place chocks under the wheels.
Set ignition key (1) to position "0" and pull it out.
Ignition key (1) is set to "P". With key in this position,
some electrical users are still under voltage, also
with engine shut off.
If these users remain under voltage for a long time,
the batteries may discharge and prevent a engine
start-up.
Because of this, pay attention that the ignition key is
always set to position "0", before leaving the
machine parked for long time (for instance at work
shift end).
S
CAUTION
With special attachment, move both hydraulic con-
trol levers (2) and the pedal (3) in all directions, to
allow all cylinders to release pressure.
Disconnect the pilot control.
1-18
S
S
Copyright ©
24
25
26