Bucket Disassembly And Assembly - Case WX145 Operator's Manual

SECTION 3
BUCKET DISASSEMBLY AND
ASSEMBLY
Place the working equipment on the ground.
Shim the bucket bottom.
It could overturn, when the pins are removed.
Unscrew the screws (2) and (4).
Take out pins (1) and (3).
Raise the working attachment slightly (5).
Now the bucket (6) is free.
Before assembly pins and bushings have to be
cleaned and protected against corrosion.
Assembly the new bucket in reverse sequence.
CORROSION PROTECTION FOR PINS AND
JOINTS
All pins and bearings (bushings and hubs) of the
working equipment or in equipment components
must be treated with anti-corrosive agent before fit-
ting:
- easy assembly and disassembly;
- protects against rust, oxidation and similar wear;
- prevents seizing and fretting corrosion in non-
moving parts of bearings.
Clean off grease, oil, dirt and corrosion protection
agents from pins and bearings using white spirit or
diesel fuel.
Rust patches must be thoroughly removed, if any.
All components must be sand polished and dry.
Spray or apply a thin layer of product with a brush
on pins and bearings. Pin shafts and bearings must
be completely covered by the protective layer.
If the protection layer of a pin already treated is
damaged, these areas must be touched up before
fitting the part.
3-66
Copyright ©
92
93