Case WX145 Operator's Manual page 338

TIMES SETTING
To check the down-time and the working time,
remove cover (1) from the case of the tank pump.
The down-time can be set by means of blue selector
(3), while the working time can be set by means of
red selector (2). Each one of them must be set on
15 different levels.
IMPORTANT: in the work is set a down-time of 3
hours [position 3 of selector (3)] and a working time
of 6 minutes [position 3 of selector (2)]. The down-
times and working times can be modified and reset
from the After-sales service or by an authorized
workshop.
After resetting and checking the down-time and
working time, replace and tighten the closing cover
(1).
OPERATION TEST
Turn the ignition key to position "I".
As soon as the control board of the tank pump
receives voltage, lamp (3) lights up.
Hold button (4) of control board depressed, so that
lamp (2) remains alight over 2 seconds.
During this operation the down-time shortens. Now
a normal lubrication process takes place.
At any time additional lubrications can be per-
formed. The grease coming out from the lubrication
points has to be collected and discarded according
to environmental legislation.
Copyright ©
ATTACHMENTS
71
72
73
7-41