Cab Lighting - Case WX145 Operator's Manual

SECTION 2

CAB LIGHTING

The cab interior lighting is switched on and off with
the switch (1).
The lighting can be switched on even if the ignition
key has been pulled out from the cylinder.
If the light remains accidentally alight for a longer
period (all over the week-end), the batteries may be
unnecessarily discharged.
Therefore always check that the interior lighting is
switched off, before leaving the machine.
AUXILIARY SOCKET
A socket outlet (1) is installed in the panelling on the
right behind the operator's seat.
This provides the output voltage of the voltage
transformer (12 V) for connection of the cool-box
(option).
Other electrical consumers can also be connected
as long as the maximum output of the voltage trans-
former is not exceeded.
The voltage transformer installed at the factory is
designed so as to supply not only a cassette radio
but also the cool-box (option); the maximum output
is 90 W (67 ft·lb/s).
For this reason, before connecting a device, check
the power input it requires. When the voltage trans-
former is overloaded, its temperature rises so that
the overload protection switches off and leaves the
connected unit without current. In this case pull the
plug out of the socket (1). After 5 - 10 minutes, the
overload protection has cooled down and reacti-
vates the voltage transformer.
If the overload condition persists, the thermal shut-
down does not work anymore and the fuse of the
supply line blows. To replace the fuse, the panelling
below the radio must be removed.
The socket is live when the ignition-key is pulled out
from the ignition cylinder.
A user remaining accidentally connected for a long
period (about a week-end) can cause the discharge
of the machine's batteries.
Therefore, before leaving the machine, check that
the connected user is switched off.
2-38
Copyright ©
41
42