Hydraulic Quick Coupler - Case WX145 Operator's Manual

The hydraulic quick coupler has been designed
according to the most severe quality parameters. It
corresponds to the safety rules in force. All this
though does not prevent the hazard of accidents.
For this reason it is compulsory to observe carefully
the safety rules and precautions.
Use the quick coupler only for the applications or
purposes described in this Manual.
The quick coupler has been designed to allow the
quick replacement of attachments.
Any modification or adaptation, not expressly
approved by the Manufacturer, causes the non con-
formity of the quick coupler with the safety prescrip-
tions.
SAFETY INSTRUCTIONS
Do not use the quick coupler before to have read
carefully and well understood the instructions and
safety prescriptions, indicated in this Manual.
During the machine operation, the switch for quick
coupler locking and unlocking must always be set to
"locked" position.
Check daily that the quick coupler does not show
hydraulic oil leak. Possibly tighten the connectors or
replace the concerned pieces.
Check that the safety rod operates correctly and
that it is not jammed because of foreign bodies.
Clean the locking system.
Each time the bucket is fitted on the quick coupler,
close the bucket and lift the attachment, to check
visually and make sure that the bucket pin is cor-
rectly fitted into the hooks.
The quick coupler modifies the machine operating
range. In particular positions the attachment can hit
the machine, therefore it has to be operated always
at a certain safety distance.
The loads handling must always be performed in
strict conformity with the instructions given in this
Manual and in conformity with the rules in force.
During the handling of loads, never use the front
and rear anchoring points, as they are necessary to
fit the tool on the quick coupler.

HYDRAULIC QUICK COUPLER

The use of the quick coupler for works other than
those for which it has been planned are prohibited.
Never use the quick coupler as a hammer. Never
use the quick coupler to sweep or level the ground
or to move objects.
Never put your hands inside of the quick coupler
and never try to adjust or repair it while the engine is
running.
Check that the safety rod operates correctly and
that it is not dirty. Clean the locking system.
Unauthorized modifications of the quick coupler can
cause serious injuries. Never perform any modifica-
tion without prior approval of the Dealer. Any modifi-
cation carried out, must be in conformity with the
machine's technical specifications and must con-
form to current safety regulations.
Copyright ©
ATTACHMENTS
7-15