Storage - Case WX145 Operator's Manual

MACHINE STORAGE
If the machine is to be set out of operation for longer
periods, the following measures are recommended:
Inspect the machine. Repair damaged or worn
parts. Install new parts, if necessary.
Park the machine on a level and firm surface.
Lay the working attachment on the ground, retract-
ing the hydraulic cylinders as much as possible.
If not, coat the exposed cylinder rods with grease.
Shift all control levers to position "0".
Clean the machine.
Lubricate all grease points.
Protect all pieces against rust and dirt with a grease
coat.
Drain coolant. If the system is filled with antifreeze
mixture, draining is not necessary.
Release alternator and fan belts.
Paint parts needing it to prevent rust formation.
Carry out preservation of the engine.
Remove the batteries and store them in a dry pro-
tected place after full charging.
If not removed, disconnect battery negative cable
from the terminal (-).
Protect the machine against unauthorized starting:
- pull out the ignition key from the block
- close and lock the windows
- lock the cab door
- lock and ensure all covers
- cover all ports.
Store the machine in a dry protected place. If the
machine is parked outside, cover it with a tarpaulin
arranged so to allow ventilation. If not, humidity
harmful to the machine may result.
If the machine is to be stored for a prolonged period
of time, operate some times the travel, swing and
digging hydraulic operations at least once per
month to guarantee proper lubrication.
SECTION 6

STORAGE

ENGINE STORAGE
If the engine is to remain idle for an extended period
of time, it is necessary to take protective measures
to prevent rusting. The preservative measures
described here will protect the engine for up to 6
months.
The procedure will have to be reversed before the
engine is recommissioned.
Anti-corrosion oils to specification:
- MIL-L-21260B.
- TL 9150-037/2.
- Nato Code C 640 / 642.
Anti-corrosion media for exterior protection only to
specification:
- Nato Code C 632.
Recommended cleaning agent to remove preserva-
tives:
- Petroleum benzine (hazardous materials class
A3).
To store the engine, perform following operations:
Clean the engine.
Clean engine with high-pressure equipment.
Run engine up to operating temperature, then
switch off.
Drain engine oil and fill with anticorrosion oil.
Drain fuel from tank.
Prepare fuel mixture from 90% diesel and 10% anti-
corrosion oil and fill up tank.
Run engine for approximately 10 minutes.
Shut off the engine.
Race engine repeatedly by hand for cylinder and
combustion chamber preservation.
Dismantle V-belts and store in packaged form.
Spray V-belt pulley grooves with anti-corrosion
agent.
Close intake and exhaust ports.
Copyright ©
6-1