Case WX145 Operator's Manual page 311

SECTION 7
If the settings for shears 3 are to be changed,
depress the button with the downward arrow (⇓).
Enter the four digit code and change the settings
with the arrow buttons. Depress the button with the
upward arrow (⇑), the number increases of one unit.
By depressing the button with the downward arrow
(⇓), the number decreases of one unit. By depress-
ing button "set", the setting is confirmed and the cur-
sor slides to the right. When the cursor is on the last
digit of a set value, a press on the "set" button
moves it on to the first digit of the next set value.
Both for pressure and volume flow limit values are
preset. If during the setting phase they are
exceeded, the indication sets to value 9999 (pres-
sure or volume flow unlimited). With reset (button
with downward arrow), the previous value, lower
than the limit value, is restored.
After changing the set values, depress the "set" but-
ton. The following options are available:
- to reject selected shears 3 with the newly selected
values and to retain the setting of shears 2.
Depress the button with the upward arrow (⇑);
- to activate shears 3 with the changed settings:
depress the "set" button. The setting is saved.
The arrow buttons always scroll to higher menu.
The return to the next higher menu is automatic if
the buttons are not pressed for a prolonged period.
For queries concerning the hydraulic oil volume flow
and oil pressure settings or the specified setting
range please contact our Service Department.
7-14
Copyright ©