HP A8800 Configuration Manual page 290

[PE2-bgp] peer 1.1.1.1 group pe2-pe1
[PE2-bgp] group pe2-pe3 external
[PE2-bgp] peer pe2-pe3 as-number 200
[PE2-bgp] peer pe2-pe3 route-policy map1 export
[PE2-bgp] peer pe2-pe3 label-route-capability
[PE2-bgp] peer pe2-pe3 connect-interface loopback 1
[PE2-bgp] peer 1.1.1.3 group pe2-pe3
[PE2–bgp] quit
# Configure OSPF.
[PE2] ospf 1
[PE2-ospf-1] area 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] network 1.1.1.2 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] network 11.11.11.11 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] network 10.10.0.0 0.0.255.255
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
# Configure a route policy.
[PE2] route-policy map1 permit node 10
[PE2-route-policy] apply mpls-label
[PE2-route-policy] quit
[PE2] route-policy map2 permit node 10
[PE2-route-policy] if-match mpls-label
[PE2-route-policy] apply mpls-label
[PE2-route-policy] quit
3. Configure PE 3:
# Configure a Router ID, enable IP multicast routing on the public network, configure an MPLS LSR
ID, and enable the LDP capability.
<PE3> system-view
[PE3] router id 1.1.1.3
[PE3] multicast routing-enable
[PE3] mpls lsr-id 1.1.1.3
[PE3] mpls
[PE3-mpls] quit
[PE3] mpls ldp
[PE3-mpls-ldp] quit
# Assign an IP address, and enable PIM-SM and LDP capability on the public network interface
GigabitEthernet 4/1/1.
[PE3] interface GigabitEthernet 4/1/1
[PE3-GigabitEthernet4/1/1] ip address 10.10.2.1 24
[PE3-GigabitEthernet4/1/1] pim sm
[PE3-GigabitEthernet4/1/1] mpls
[PE3-GigabitEthernet4/1/1] mpls ldp
[PE3-GigabitEthernet4/1/1] quit
# Assign an IP address, and enable PIM-SM and MPLS on the public network interface
GigabitEthernet 4/1/2.
[PE3] interface GigabitEthernet 4/1/2
[PE3-GigabitEthernet4/1/2] ip address 192.168.1.2 24
278