Ipv6 Multicast Vlan Configuration Examples - HP A8800 Configuration Manual

IPv6 multicast VLAN configuration examples

Network requirements
As shown in
the MLD querier.
The IPv6 multicast source sends IPv6 multicast data to the IPv6 multicast group FF1E::101. Host A, Host B,
and Host C are receivers of the IPv6 multicast group, and they belong to VLAN 2 through VLAN 4
respectively.
Configure the sub-VLAN-based IPv6 multicast VLAN feature on Switch A so that Router A just sends IPv6
multicast data to Switch A through the IPv6 multicast VLAN and Switch A forwards the traffic to the
receivers that belong to different user VLANs.
Figure 89 Network diagram
Source
1::1/64
Receiver
VLAN 2
Configuration procedure
1. Configure Router A:
# Enable IPv6 forwarding and IPv6 multicast routing.
<RouterA> system-view
[RouterA] ipv6
[RouterA] multicast ipv6 routing-enable
# Configure an IPv6 address for GigabitEthernet 3/1/2 and enable IPv6 PIM-DM.
[RouterA] interface GigabitEthernet 3/1/2
[RouterA-GigabitEthernet3/1/2] ipv6 address 1::2 64
[RouterA-GigabitEthernet3/1/2] pim ipv6 dm
[RouterA-GigabitEthernet3/1/2] quit
# Create VLAN 10. Configure GigabitEthernet 3/1/1 as a hybrid port and to permit packets from
VLAN 10 to pass and tag the packets when forwarding them.
Figure 89, MLDv1 runs on Router A, MLD snooping runs on Switch A, and Router A acts as
MLD querier
GE3/1/2
Router A
1::2/64
GE3/1/1
Vlan-int 10
2001::1/64
GE3/1/1
Switch A
GE3/1/2
GE3/1/3
Host A
VLAN 3
GE3/1/4
Receiver
Host B
VLAN 4
328
Receiver
Host C