Enabling Ipv6 Pim-Sm - HP A8800 Configuration Manual

Determine the IPv6 address of a static RP and the IPv6 ACL that defines the range of IPv6 multicast
•
groups to be served by the static RP.
Determine the C-RP priority and the IPv6 ACL that defines the range of IPv6 multicast groups to be
•
served by each C-RP.
Determine the legal C-RP address range and the IPv6 ACL that defines the range of IPv6 multicast
•
groups to be served.
Determine the C-RP-Adv interval.
•
• Determine the C-RP timeout.
Determine the C-BSR priority.
•
Determine the hash mask length.
•
Determine the IPv6 ACL that defines the legal BSR address range.
•
Determine the BS period.
•
• Determine the BS timeout timer.

Enabling IPv6 PIM-SM

You must enable IPv6 PIM-SM before enabling IPv6 BIDIR-PIM because IPv6 BIDIR-PIM is implemented on
the basis of IPv6 PIM-SM. To deploy an IPv6 BIDIR-PIM domain, enable IPv6 PIM-SM on all non-border
interfaces of the domain.
On a router, all interfaces in the same VPN instance must operate in the same IPv6 PIM mode.
To enable IPv6 PIM-SM:
Step
1. Enter system view.
2. Enable IPv6 multicast routing.
3. Enter interface view.
4. Enable IPv6 PIM-SM.
Enabling IPv6 BIDIR-PIM
The router supports IPv6 BIDIR-PIM only when the system is operating in SPE mode. For more information
about system operating modes, see Fundamentals Configuration Guide.
If BIDIR-PIM is enabled on the public network or in a VPN, the tunnel interfaces on the public network or
in the VPN do not support Layer 3 multicasting.
Perform this configuration on all routers in the IPv6 BIDIR-PIM domain.
To enable IPv6 BIDIR-PIM:
Step
1. Enter system view.
2. Enter IPv6 PIM view.
Command
system-view
multicast ipv6 routing-enable
interface interface-type
interface-number
pim ipv6 sm
Command
system-view
pim ipv6
403
Remarks
N/A
Disable by default.
N/A
Disabled by default.
Remarks
N/A
N/A