Digest Snooping Configuration Example - HP 5120 EI Series Lan Switching Configuration Manual

Step
2. Enter interface view or port
group view.
3. Enable Digest Snooping on
the interface or port group.
4. Return to system view.
5. Enable global Digest
Snooping.

Digest Snooping configuration example

Network requirements
As shown in
these devices are in the same region.
Enable Digest Snooping on the ports of Device A and Device B that connect to Device C, so that the three
devices can communicate with one another.
Figure 23 Digest Snooping configuration
Configuration procedure
# Enable Digest Snooping on GigabitEthernet 1/0/1 of Device A and enable global Digest
Snooping on Device A.
<DeviceA> system-view
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] stp config-digest-snooping
[DeviceA-GigabitEthernet1/0/1] quit
Figure 23, Device A and Device B connect to Device C, which is a third-party device. All
Command
•
Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
stp config-digest-snooping
quit
stp config-digest-snooping
90
Remarks
Use either command.
Disabled by default.
N/A
Disabled by default.