Setting The Maximum Number Of Forwarding Entries For Ipv6 Multicast Vlans - HP A8800 Configuration Manual

The VLANs to be configured as the sub-VLANs of the IPv6 multicast VLAN must exist and must not
•
be sub-VLANs of another IPv6 multicast VLAN.
To configure sub-VLAN-based IPv6 multicast VLAN:
Step
1. Enter system view.
2. Configure the specified VLAN
as an IPv6 multicast VLAN
and enter IPv6 multicast
VLAN view.
3. Configure the specified
VLANs as sub-VLANs of the
IPv6 multicast VLAN.
Setting the maximum number of forwarding entries
for IPv6 multicast VLANs
You can set the maximum number of entries in the MLD snooping forwarding table for IPv6 multicast
VLANs. When the number of forwarding entries maintained for the IPv6 multicast VLANs reaches the
upper limit, the system does not automatically remove any existing entries or create new entries. HP
recommends that you remove excessive entries manually.
To set the maximum number of entries in the forwarding table:
Step
1. Enter system view.
2. Set the maximum number of
forwarding entries for IPv6
multicast VLANs.
Displaying and maintaining IPv6 multicast VLAN
Task
Display information about an IPv6
multicast VLAN.
Command
system-view
multicast-vlan ipv6 vlan-id
subvlan vlan-list
Command
system-view
multicast-vlan ipv6 entry-limit limit
Command
display multicast-vlan ipv6
[ vlan-id ] [ | { begin | exclude |
include } regular-expression ]
327
Remarks
N/A
By default, no IPv6 multicast VLAN
is configured.
By default, an IPv6 multicast VLAN
has no sub-VLANs.
Remarks
N/A
By default, the maximum number
varies with the system operating
modes as follows:
•
In SPE mode—1024.
•
In SPC mode—4095.
•
In hybrid mode—1024.
For more information about the
system operating modes, see
Fundamentals Configuration
Guide.
Remarks
Available in any view.