Configuring Static Ports - HP A8800 Configuration Manual

Setting the global aging timers for dynamic ports
Step
1. Enter system view.
2. Enter MLD snooping view.
3. Set the global aging timer for
dynamic router ports.
4. Set the global aging timer for
dynamic member ports.
Setting the aging timers for the dynamic ports in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the aging timer for the
dynamic router ports.
4. Set the aging timer for the
dynamic member ports.

Configuring static ports

If all the hosts attached to a port is interested in the IPv6 multicast data addressed to a particular IPv6
multicast group, you can configure that port as a static member port for that IPv6 multicast group.
You can configure a port as a static router port, through which the router can forward all IPv6 multicast
data it received.
Configuration guidelines
A static member port does not respond to queries from the MLD querier. When you configure a port as
a static member port or cancel this configuration on the port, the port does not send an unsolicited MLD
report or an MLD done message.
Static member ports and static router ports never age out. To remove such a port, use the corresponding
undo command.
Configuration procedure
To configure static ports:
Step
1. Enter system view.
Command
system-view
mld-snooping
router-aging-time interval
host-aging-time interval
Command
system-view
vlan vlan-id
mld-snooping router-aging-time
interval
mld-snooping host-aging-time
interval
Command
system-view
295
Remarks
N/A
N/A
260 seconds by default.
260 seconds by default.
Remarks
N/A
N/A
260 seconds by default.
260 seconds by default.
Remarks
N/A