HP A8800 Configuration Manual page 47

[DeviceA-GigabitEthernet2/1/3] quit
[DeviceA] interface GigabitEthernet 2/1/4
[DeviceA-GigabitEthernet2/1/4] port link-mode bridge
[DeviceA-GigabitEthernet2/1/4] quit
[DeviceA] vlan 100
[DeviceA-vlan100] port GigabitEthernet 2/1/1 to GigabitEthernet 2/1/4
[DeviceA-vlan100] igmp-snooping enable
[DeviceA-vlan100] igmp-snooping drop-unknown
[DeviceA-vlan100] quit
# Configure a multicast group filter so that the receiver hosts in the VLAN can receive multicast
data for multicast group 224.1.1.1 only.
[DeviceA] acl number 2001
[DeviceA-acl-basic-2001] rule permit source 224.1.1.1 0
[DeviceA-acl-basic-2001] quit
[DeviceA] igmp-snooping
[DeviceA-igmp-snooping] group-policy 2001 vlan 100
[DeviceA-igmp-snooping] quit
# Configure GigabitEthernet 2/1/3 and GigabitEthernet 2/1/4 to join multicast group
224.1.1.1 as simulated member hosts.
[DeviceA] interface GigabitEthernet 2/1/3
[DeviceA-GigabitEthernet2/1/3] igmp-snooping host-join 224.1.1.1 vlan 100
[DeviceA-GigabitEthernet2/1/3] quit
[DeviceA] interface GigabitEthernet 2/1/4
[DeviceA-GigabitEthernet2/1/4] igmp-snooping host-join 224.1.1.1 vlan 100
[DeviceA-GigabitEthernet2/1/4] quit
Verify the configuration
# Display detailed IGMP snooping group information in VLAN 100 on Device A.
[DeviceA] display igmp-snooping group vlan 100 verbose
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, C-Copy port, P-PIM port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port unit board: Mask(0x000004)
Router port(s):total 1 port(s).
IP group(s):the following ip group(s) match to one mac group.
IP group address:224.1.1.1
(0.0.0.0, 224.1.1.1):
GE2/1/1
Attribute: Host Port
Host port unit board: Mask(0x000004)
Host port(s):total 2 port(s)..
(D)
35