Configuring The Maximum Number Of Ecmp Routes - HP A8800 Configuration Manual

Table 32 Description of the send, receive, and both parameters and the negotiation result
Local parameter
send
receive
both

Configuring the maximum number of ECMP routes

Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 MBGP address
family view.
4. Configure the maximum
number of ECMP routes for
load balancing.
Configuring a large scale IPv6 MBGP network
Configuration prerequisites
Before you configure the following tasks, you must configure IPv6 MBGP basic functions.
Configuring an IPv6 MBGP peer group
For easy management and configuration, you can organize some IPv6 MBGP peers that have the same
route update policy into a peer group. A policy configured for a peer group applies to all the members
in the group.
To create an IPv6 MBGP peer group, you must enable an existing IPv6 unicast peer group in IPv6 MBGP
address family view.
Before adding an IPv6 MBGP peer to the IPv6 MBGP peer group, you must add the corresponding IPv6
BGP unicast peer to the corresponding IPv6 BGP unicast peer group.
To configure an IPv6 MBGP peer group:
Step
Enter system view.
1.
Peer parameter
•
receive
•
both
•
send
•
both
both
Command
system-view
bgp as-number
ipv6-family multicast
balance [ ebgp | ibgp ] number
Command
system-view
462
Negotiation result
The ORF sending capability is enabled locally and
the ORF receiving capability is enabled on the
peer.
The ORF receiving capability is enabled locally and
the ORF sending capability is enabled on the peer.
Both the ORF sending and receiving capabilities
are enabled locally and on the peer.
Remarks
N/A
N/A
N/A
By default, load balancing is
disabled.
Remarks
N/A