HP A8800 Configuration Manual page 380

Configuration procedure
1. Enable IPv6 forwarding on each router and assign an IPv6 address and prefix length to each
interface as shown in
document.
2. Configure OSPF among the routers to make sure the network-layer is interoperable among the
routers on the IPv6 PIM-SSM domain and routing information among the routers can be
dynamically updated. (Details not shown.)
3. Enable IPv6 multicast routing, enable MLD and MLD SSM mapping on the host-side interface, and
enable IPv6 PIM-SM on each interface:
# On Router D, enable IPv6 multicast routing globally, enable MLD (version 2) and MLD SSM
mapping on GigabitEthernet 3/1/1, and enable IPv6 PIM-SM on each interface.
<RouterD> system-view
[RouterD] multicast ipv6 routing-enable
[RouterD] interface GigabitEthernet 3/1/1
[RouterD-GigabitEthernet3/1/1] mld enable
[RouterD-GigabitEthernet3/1/1] mld version 2
[RouterD-GigabitEthernet3/1/1] mld ssm-mapping enable
[RouterD-GigabitEthernet3/1/1] pim ipv6 sm
[RouterD-GigabitEthernet3/1/1] quit
[RouterD] interface GigabitEthernet3/1/2
[RouterD-GigabitEthernet3/1/2] pim ipv6 sm
[RouterD-GigabitEthernet3/1/2] quit
[RouterD] interface GigabitEthernet3/1/3
[RouterD-GigabitEthernet3/1/3] pim ipv6 sm
[RouterD-GigabitEthernet3/1/3] quit
# On Router A, enable IPv6 multicast routing globally, and enable IPv6 PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] pim ipv6 sm
[RouterA-GigabitEthernet3/1/1] quit
[RouterA] interface GigabitEthernet 3/1/2
[RouterA-GigabitEthernet3/1/2] pim ipv6 sm
[RouterA-GigabitEthernet3/1/2] quit
[RouterA] interface GigabitEthernet 3/1/3
[RouterA-GigabitEthernet3/1/3] pim ipv6 sm
[RouterA-GigabitEthernet3/1/3] quit
# Enable IPv6 multicast routing and IPv6 PIM-SM on Router B and Router C in the same way.
(Details not shown.)
4. Configure C-BSR and C-RP interfaces on Router D.
[RouterD] pim ipv6
[RouterD-pim6] c-bsr 1003::2
[RouterD-pim6] c-rp 1003::2
[RouterD-pim6] quit
5. Configure the IPv6 SSM group range:
# Configure the IPv6 SSM group range FF3E::/64 on Router D.
[RouterD] acl ipv6 number 2000
Figure 100. The detailed configuration steps are not discussed in this
368