Anycast Rp Configuration - HP A8800 Configuration Manual

Anycast RP configuration

Network requirements
The PIM-SM domain in this example has multiple multicast sources and receivers. OSPF runs within the
domain to provide unicast routes.
Configure the Anycast RP application so that the receiver-side DRs and the source-side DRs can initiate
a Join message to their respective RPs that are the topologically nearest to them.
On Router B and Router D, configure the interface Loopback 10 as a C-BSR, and Loopback 20 as a C-RP.
The router ID of Router B is 1.1.1.1, while the router ID of Router D is 2.2.2.2. Set up an MSDP peering
relationship between Router B and Router D.
Figure 61 Network diagram
Table 16 shows the interface and IP address assignment, and network topology scheme.
Table 16 Interface and IP address assignment
Device
Source 1
Source 2
Router A
Router B
Router B
Router B
Router B
Router B
Interface IP address
— 10.110.5.100/24
— 10.110.6.100/24
GE3/1/1 10.110.5.1/24
S4/1/9/1:0 10.110.2.2/24
GE3/1/1 10.110.1.1/24
S4/1/9/1:0 10.110.2.1/24
POS5/1/1 192.168.1.1/24
Loop0 1.1.1.1/32
Loop10 3.3.3.3/32
Device
Router C
Router C
Router D
Router D
Router D
Router D
Router D
Router D
210
Interface IP address
POS5/1/1 192.168.1.2/24
POS5/1/2 192.168.2.2/24
GE3/1/1 10.110.3.1/24
S4/1/9/1:0 10.110.4.1/24
POS5/1/1 192.168.2.1/24
Loop0 2.2.2.2/32
Loop10 4.4.4.4/32
Loop20 10.1.1.1/32