Configuring Basic Ipv6 Mbgp Functions - HP A8800 Configuration Manual

Task
Tuning and optimizing IPv6 MBGP
networks
Configuring a large scale IPv6
MBGP network

Configuring basic IPv6 MBGP functions

Configuration prerequisites
IPv6 MBGP is an application of multiprotocol BGP. Before you configure IPv6 MBGP, complete the
following tasks:
Enable IPv6.
•
Configure network layer addresses for interfaces.
•
Complete BGP basic configuration.
•
Configuring an IPv6 MBGP peer
Step
1. Enter system view.
2. Enable BGP and enter BGP
view.
3. Enter IPv6 address family
view.
4. Specify a IPv6 BGP peer and
its AS number.
5. Enter IPv6 MBGP address
family view.
6. Enable the IPv6 MBGP peer.
Configuring a preferred value for routes from a peer or a peer
group
If you both reference a routing policy and use the command peer { ipv6-group-name | ipv6-address }
preferred-value value to set a preferred value for routes from a peer or a peer group, the routing policy
sets the specified preferred value for routes that match it. Other routes that do not match the routing policy
Configuring the AS_PATH attribute
Configuring IPv6 MBGP soft reset
Enabling the IPv6 MBGP ORF capability
Configuring the maximum number of ECMP routes
Configuring an IPv6 MBGP peer group
Configuring IPv6 MBGP community
Configuring an IPv6 MBGP route reflector
Command
system-view
bgp as-number
ipv6-family
peer ipv6-address as-number
as-number
ipv6-family multicast
peer ipv6-address enable
452
Remarks
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
N/A
Not enabled by default.
N/A
Not configured by default.
N/A
Not enabled by default.