HP A8800 Configuration Manual page 319

Figure 81 Network diagram
Configuration procedure
1. Enable IPv6 forwarding and assign an IPv6 address and prefix length to each interface as
per Figure
2. On Router A, enable IPv6 multicast routing, enable MLDv1 on GigabitEthernet 3/1/1, and enable
IPv6 PIM-DM on each interface.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] mld enable
[RouterA-GigabitEthernet3/1/1] pim ipv6 dm
[RouterA-GigabitEthernet3/1/1] quit
[RouterA] interface GigabitEthernet 3/1/2
[RouterA-GigabitEthernet3/1/2] pim ipv6 dm
[RouterA-GigabitEthernet3/1/2] quit
3. Configure Router B:
# Enable MLD snooping globally.
<RouterB> system-view
[RouterB] mld-snooping
[RouterB-mld-snooping] quit
# Create VLAN 100, assign GigabitEthernet 3/1/1 through GigabitEthernet 3/1/4 to this VLAN,
and enable MLD snooping and the function of dropping unknown IPv6 multicast packets in the
VLAN.
[RouterB] vlan 100
[RouterB-vlan100] port GigabitEthernet 3/1/1 to GigabitEthernet 3/1/4
[RouterB-vlan100] mld-snooping enable
[RouterB-vlan100] mld-snooping drop-unknown
# Configure an IPv6 multicast group filter so that the receiver hosts in the VLAN can receive IPv6
multicast data for group FF1E::101 only.
[RouterB] acl ipv6 number 2001
[RouterB-acl6-basic-2001] rule permit source ff1e::101 128
81. (Details not shown.)
307