HP A8800 Configuration Manual page 183

Configuration procedure
1. Configure the IP address and subnet mask for each interface as per
2. Configure OSPF for interoperation among the routers in the PIM-SM domain. Ensure the
network-layer interoperation among the routers in the PIM-SM domain and enable dynamic
update of routing information among the routers through a unicast routing protocol. (Details not
shown.)
3. Enable IP multicast routing and administrative scoping, and enable PIM-SM and IGMP:
# Enable IP multicast routing and administrative scoping on Router A, enable PIM-SM on each
interface, and enable IGMP on the host-side interface GigabitEthernet 4/1/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] pim
[RouterA-pim] c-bsr admin-scope
[RouterA-pim] quit
[RouterA] interface GigabitEthernet 4/1/1
[RouterA-GigabitEthernet4/1/1] igmp enable
[RouterA-GigabitEthernet4/1/1] pim sm
[RouterA-GigabitEthernet4/1/1] quit
[RouterA] interface serial 4/1/9/1:0
[RouterA-Serial4/1/9/1:0] pim sm
[RouterA-Serial4/1/9/1:0] quit
# Enable IP multicast routing and administrative scoping, and enable PIM-SM and IGMP on Router
E and Router I in the same way. (Details not shown.)
# On Router B, enable IP multicast routing and administrative scoping, and enable PIM-SM on
each interface.
<RouterB> system-view
[RouterB] multicast routing-enable
[RouterB] pim
[RouterB-pim] c-bsr admin-scope
[RouterB-pim] quit
[RouterB] interface GigabitEthernet 4/1/1
[RouterB-GigabitEthernet4/1/1] pim sm
[RouterB-GigabitEthernet4/1/1] quit
[RouterB] interface serial 4/1/9/1:0
[RouterB-Serial4/1/9/1:0] pim sm
[RouterB-Serial4/1/9/1:0] quit
[RouterB] interface Pos 5/1/1
[RouterB-Pos5/1/1] pim sm
[RouterB-Pos5/1/1] quit
[RouterB] interface pos 5/1/2
[RouterB-Pos5/1/2] pim sm
[RouterB-Pos5/1/2] quit
# Enable IP multicast routing and administrative scoping, and enable PIM-SM on Router C, Router
D, Router F, Router G, and Router H in the same way. (Details not shown.)
4. Configure an admin-scoped zone boundary:
# On Router B, configure POS 5/1/1 and POS 5/1/2 as the boundary of admin-scoped zone 1.
[RouterB] interface Pos 5/1/1
171
Figure 52. (Details not shown.)