Configuration Procedure - HP A8800 Configuration Manual

Configuration procedure

To configure a sub-VLAN-based multicast VLAN:
Step
1. Enter system view.
2. Configure the specified VLAN
as a multicast VLAN and enter
multicast VLAN view.
3. Assign the specified VLANs to
the multicast VLAN.
Configuring the maximum number of forwarding
entries in a multicast VLAN
You can configure the maximum number of entries in the IGMP snooping forwarding table of a multicast
VLAN. When the number of forwarding entries maintained for a multicast VLAN reaches the upper limit,
the system does not automatically remove any existing entries or create any new entries. HP recommends
that you remove excessive entries manually.
To configure the maximum number of entries in the forwarding table:
Step
1. Enter system view.
2. Configure the maximum
number of forwarding entries
in a multicast VLAN.
Displaying and maintaining a multicast VLAN
Task
Display information about a
multicast VLAN.
Command
system-view
multicast-vlan vlan-id
subvlan vlan-list
Command
system-view
multicast-vlan entry-limit limit
Command
display multicast-vlan [ vlan-id ] [ |
{ begin | exclude | include }
regular-expression ]
56
Remarks
N/A
By default, a VLAN is not a
multicast VLAN.
By default, a multicast VLAN has
no sub-VLANs.
Remarks
N/A
The default upper limit varies with
the system operating modes as
follows:
•
In SPE or SPC mode—16384.
•
In hybrid mode—13824.
For more information about the
system operating modes, see
Fundamentals Configuration
Guide.
Remarks
Available in any view.