HP A8800 Configuration Manual page 479

Figure 120 Network diagram
Device
Source
Router A
Router B
Configuration procedure
1. Enable IPv6 and configure IPv6 addresses and prefixes for interfaces. (Details not shown.)
2. Configure OSPFv3 for routers in AS 200 to make sure they can reach each other at the network
layer. (Details not shown.)
3. Enable IPv6 multicast routing, IPv6 PIM-SM and MLD, and configure an IPv6 PIM-SM domain
border:
# Enable IPv6 multicast routing on Router A, and enable PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] pim ipv6 sm
[RouterA-GigabitEthernet3/1/1] quit
[RouterA] interface POS 5/1/1
[RouterA-Pos5/1/1] pim ipv6 sm
[RouterA-Pos5/1/1] quit
# Configure Router B and Router D in the same way. (Details not shown.)
# Enable IPv6 multicast routing on Router C, enable IPv6 PIM-SM on each interface, and enable
MLD on the host-side interface GigabitEthernet 3/1/1.
<RouterC> system-view
[RouterC] multicast ipv6 routing-enable
[RouterC] interface serial 4/1/9/1:1
[RouterC-Serial4/1/9/1:1] pim ipv6 sm
[RouterC-Serial4/1/9/1:1] quit
Interface IP address
N/A 1002::100/64
GE3/1/1 1002::1/64
POS5/1/1 1001::1/64
POS5/1/1 1001::2/64
S4/1/9/1:1 2001::1/64
S4/1/9/1:2 2002::1/64
Device Interface
Router C GE3/1/1
S4/1/9/1:1
S4/1/9/1:2
Router D S4/1/9/1:1
S4/1/9/1:2
467
IP address
3002::1/64
3001::1/64
2001::2/64
2002::2/64
3001::2/64