Ipv6 Global Address Setup - ZyXEL Communications GS3700 Series User Manual

Table 28 Basic Set t ing > I Pv6 > I Pv6 Configurat ion > I Pv6 Link- Local Address Set up ( cont inued)
LABEL
Default Gat eway
Apply
Cancel
Clear
I ndex
I nt erface
I Pv6 Link- Local
Address
I Pv6 Default
Gat eway

6.9.6 IPv6 Global Address Setup

Use t his screen t o configure t he int erface's I Pv6 global address. Click t he link next t o I Pv6 Globa l
Addr e ss Se t u p in t he I Pv6 Con figur a t ion screen t o display t he screen as shown next .
Figure 49 Basic Set t ing > I Pv6 > I Pv6 Configurat ion > I Pv6 Global Address Set up
The following t able describes t he labels in t his screen.
Table 29 Basic Set t ing > I Pv6 > I Pv6 Configurat ion > I Pv6 Global Address Set up
LABEL
I nt erface
I Pv6 Global Address
Prefix Lengt h
EUI - 64
Add
Cancel
Clear
Chapter 6 Basic Setting
DESCRIPTION
Set t he default gat eway I Pv6 address for t he int erface. When an int erface cannot find
a rout ing inform at ion for a fram e's dest inat ion, it forwards t he packet t o t he default
gat eway.
Click Apply t o save your changes t o t he Swit ch's run- t im e m em ory. The Swit ch loses
t hese changes if it is t urned off or loses power, so use t he Sa ve link on t he t op
navigat ion panel t o save your changes t o t he nonvolat ile m em ory when you are done
configuring.
Click Ca nce l t o begin configuring t his screen afresh.
Click Cle a r t o reset t he fields t o t he fact ory default s.
This is t he int erface index num ber. Click on an index num ber t o change t he set t ings.
This is t he nam e of t he I Pv6 int erface you creat ed.
This is t he st at ic I Pv6 link- local address for t he int erface.
This is t he default gat eway I Pv6 address for t he int erface.
DESCRIPTION
Select t he I Pv6 int erface you want t o configure.
Manually configure a st at ic I Pv6 global address for t he int erface.
Specify an I Pv6 prefix lengt h t hat specifies how m any m ost significant bit s ( st art from
t he left ) in t he address com pose t he net work address.
Select t his opt ion t o have t he int erface I D be generat ed aut om at ically using t he EUI -
64 form at .
Click Add t o creat e a new ent ry or updat e an exist ing one.
Click Ca nce l t o begin configuring t his screen afresh.
Click Cle a r t o reset t he fields t o t he fact ory default s.
GS3700/XGS3700 Series User's Guide
86