ZyXEL Communications GS3700 Series User Manual page 98

2 Aft er reboot com plet es, t he m ast er LED will t urn on.
3
Configure t he Swit ch st acking priorit y t o a high value, such as 63.
4
Change a second Swit ch t o st acking m ode and wait for it t o finish reboot ing aut om at ically. This
m ast er LED will also t urn on.
5
Connect t he t wo Swit ches using t he st acking port s for t he Swit ch defined.
6
The second Swit ch m ast er LED will t hen t urn off, and it s Sys LED will blink while it 's init ializing.
Please wait unt il it st ops blinking, indicat ing t hat it has j oined t he st ack.
7 Repeat st eps 4 t o 6 t o connect ot her Swit ches t o t he st ack.
When t he Swit ch is in St acking m ode, t he web configurat or will change port and VLAN port set t ings
t o support t he st acking m ode. See
on t he port set t ings.
Click Ba sic Se t t ing > St a ck ing > Configur a t ion t o see t he following screen.
Figure 59 Basic Set t ing > St acking > Configurat ion
Chapter 6 Basic Setting
Sect ion 6.6 on page 69
GS3700/XGS3700 Series User's Guide
98
and Sect ion 7.7 on page 106 for det ails