Lldp Configuration Basic Tlv Setting - ZyXEL Communications GS3700 Series User Manual

Table 174 Advanced Applicat ion > LLDP > LLDP Configurat ion
LABEL
Adm in St at us
Not ificat ion
Apply
Cancel

35.6.1 LLDP Configuration Basic TLV Setting

Use t his screen t o configure Basic TLV set t ings. Click Adva nce d Applica t ion > LLD P > LLD P
Con figu r a t ion > Ba sic TLV Se t t in g t o display t he screen as shown next .
Figure 262 Advanced Applicat ion > LLDP > LLDP Configurat ion> Basic TLV Set t ing ( St andalone
m ode)
Chapter 35 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Select whet her LLDP t ransm ission and/ or recept ion is allowed on t his port .
• Disable - not allowed
• Tx- Only - t ransm it only
• Rx- Only - receive only
• Tx- Rx - t ransm it and receive
Select whet her LLDP not ificat ion is enabled on t his port .
Click Apply t o save your changes t o t he Swit ch's run- t im e m em ory. The Swit ch loses
t hese changes if it is t urned off or loses power, so use t he Sa ve link on t he t op
navigat ion panel t o save your changes t o t he non- volat ile m em ory when you are done
configuring.
Click Ca n ce l t o begin configuring t his screen afresh.
GS3700/XGS3700 Series User's Guide
361