ZyXEL Communications GS3700 Series User Manual page 315

Figure 226 Advanced Applicat ion > sFlow > Collect or
The following t able describes t he labels in t his screen.
Table 147 Advanced Applicat ion > sFlow > Collect or
LABEL DESCRIPTION
Collect or Ent er t he I P address of t he sFlow collect or.
Address
UDP Port Ent er a UDP port num ber t he Swit ch uses t o send sFlow dat agram t o t he collect or. I f you
change t he port here, m ake sure you change it on t he collect or, t oo. The default port is
6343.
Add Click t his t o creat e a new ent ry or t o updat e an exist ing one.
This saves your changes t o t he Swit ch's run- t im e m em ory. The Swit ch loses t hese changes
if it is t urned off or loses power, so use t he Sa ve link on t he t op navigat ion panel t o save
your changes t o t he non-volat ile m em ory when you are done configuring.
Cancel Click Ca n ce l t o reset t he fields t o your previous configurat ion.
Clear Click Cle a r t o reset t he fields t o t he fact ory default s.
I ndex This field displays t he index num ber of t his ent ry. Click on an index num ber t o change t he
set t ings.
Collect or This field displays I P address of t he sFlow collect or.
Address
UDP Port This field displays port num ber t he Swit ch uses t o send sFlow dat agram t o t he collect or.
Delet e Check t he rule( s) t hat you want t o rem ove in t he D e le t e colum n and t hen click t he D e le t e
but t on.
Cancel Click Ca n ce l t o begin configuring t his screen afresh.
Chapter 29 sFlow
GS3700/XGS3700 Series User's Guide
315