Advanced Options - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

Advanced Options

• User Traffic Profile: If you want this WLAN to use a user traffic profile that you
previously created, select it from the drop-down menu. Otherwise, select
System Default.
• L2 Access Control: If you want this WLAN to use an L2 access control policy
that you previously created, select it from the drop-down menu. Otherwise,
select Disable.
• OS Policy: If you want this WLAN to apply a unique policy to devices based
on OS type. Use a precedence profile to determine whether a role-based,
AAA-based, or OS-based policy will take precedence. Otherwise, select
Disable.
• Application Recognition and Control: Enable DPI-based L7 application
recognition, and if enabled, an application control policy. Recognition and
control are performed on the AP.
• Client Fingerprinting: Enable the AP to attempt utilize DHCP fingerprinting to
identify client devices by their operating system, device type, and host name.
• Access VLAN: Tag the WLAN traffic with a VLAN ID between 2 and 4094. By
default, all client traffic will be assigned to the native (untagged) VLAN on the
AP's Ethernet port, which we represent as VLAN ID 1.
• Hide SSID: Remove the SSID from beacon frames. By removing the SSID,
in most cases, clients will not show this SSID in their scan list unless the
device is already configured to connect. This can simplify the network
decision for an end user.
• Client Load Balancing: To disable client load balancing on this WLAN, select
the Do not perform client load balancing for this WLAN service check
box.
• Proxy ARP: Enable proxy ARP on a WLAN if you want APs to provide proxy
service for stations when receiving neighbor discovery packets (for example,
ARP request and ICMPv6 Neighbor Solicit messages) and to act on behalf
of the station in delivering ARP replies. When an AP receives a broadcast
ARP/Neighbor Solicit request for a known host, it replies on behalf of the
host. If the AP receives a request for an unknown host, it forwards the request.
• Max Clients: Limit the number of clients that can associate with this WLAN
per AP radio (default is 100). Every connection attempt after this max value
will not be permitted to connect.
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
Configuring the SCG for the First Time
Defining the WLAN Settings of a Zone
83