Ruckus Wireless SmartCell Gateway 200 Getting Started Manual page 43

Figure 22. The Management (Web) tab
4 On the Management (Web) tab, configure the IP address settings of the
management interface.
a Under the IPv4 section, click Static, and then enter the network settings that
you want to assign to the AP/DataPlane interface, through which client traffic
and configuration data are sent and received.
NOTE: Although it is possible to use DHCP to assign IP address settings to the
Control interface automatically, Ruckus Wireless strongly recommends assigning a
static IP address to this interface.
WARNING!
subnets. Failure to do so may result in loss of access to the web interface or failure
of system functions and services.
The following network settings are required (others are optional):
- IP address
- Netmask
- Default gateway
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
You must configure the three interfaces to be on three different
Running the Setup Wizard and Logging On to the Web Interface
Step 2: Configure the Management IP Address Settings
43