Creating A Hotspot (Wispr) Service - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

Creating a Hotspot (WISPr) Service

NOTE: If you do not want to provide a Hotspot (WISPr) service to users, skip this
step.
A hotspot service requires an AAA server. Before creating a hotspot service, make
sure you have already added an AAA server to the controller. For more information,
refer to Creating an AAA
Follow these steps to create a hotspot service for a zone.
1 Go to Services & Profiles > Hotspots & Portals.
2 Click the Hotspot (WISPr) tab.
3 From the zone and AP group tree, select the zone for which you want to create
a hotspot service.
4 Click
5 Configure the hotspot service settings listed in
Table 13. Hotspot (WISPr) service settings
Setting
General Options
Portal Name
Portal Description
Redirection: Select where to redirect the user after successfully completing
authentication.
SmartClient Support
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
Server.
. The Create Guest Access Portal form appears.
Description
Type a name for the guest access service portal that you
are creating
Type a short description of the guest access service
portal.
Click one of these options:
• None: Select this option to disable Smart Client
support on the hotspot service.
• Enable: Selection this option to enable Smart Client
support.
• Only Smart Client Allowed: Select this option to
allow only Smart Clients to connect to the hotspot
service.
Configuring the SCG for the First Time
Configuring AAA Servers and Hotspot Settings
Table 13.
70