Preparing The Administrative Computer - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

The DNS address can be configured manually or obtained automatically by the
DHCPv6 client.

Preparing the Administrative Computer

Follow these steps to prepare the administrative computer that you will use to run
the SCG Setup Wizard.
1 On the administrative computer, open the Network Connections (or Network and
Dial-up Connections) control panel according to how your Start menu is set up:
• Start > Settings > Network Connections
• Start > Control Panel > Network and Sharing Center > Change Adapter
Settings
NOTE: This procedure assumes Windows 7 as the operating system. Procedures
for other operating systems are similar.
2 When the Network Connections windows appears, right click the icon for "Local
Area Connection" and click Properties.
3 When the Local Area Connection Properties dialog box appears, click Internet
Protocol Version 4 (TCP/IPv4) from the scrolling list, then and click Properties.
The TCP/IP Properties dialog box appears.
NOTE: Write down all of the currently active settings so you can restore your
computer to its current configuration later (when this process is complete).
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
Preparing the Interface Settings and Administrative Computer
Preparing the Administrative Computer
35