Mounting The Scg Onto A Server Rack - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

Smartzone 3.5.1

Hide thumbs Also See for SmartCell Gateway 200:

Table of Contents

Mounting and Powering the SCG

Mounting the SCG onto a Server Rack

The SCG is a 2U form factor server designed for mounting onto a standard EIA 19"

server rack. The supplied mounting hardware supports mounting on server racks

that are 22.5" to 32.5" deep. For racks of depth less than 22.5", use the TMLC-

MOUNT21 rack mount kit (available at Avnet and manufactured by Kontron).

Before installing the SCG appliance onto a server rack, verify that all package

contents (see

Unpacking the

Controller) are included and ensure that you have

prepared all the required hardware and tools.

What You Will Need

• 3/8-inch hex driver or wrench

• Phillips (crosshead) screwdriver, #1 and #2 bits

• Anti-static wrist strap and conductive foam pad (recommended)

Step 1: Unpack the Rack Mount Kit

Refer to

Rack Mount Kit Contents

and verify that the rack mount kit contents are

complete.

SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A

Table of Contents

Do you have a question about the SmartCell Gateway 200 and is the answer not in the manual?

Scg200