Ruckus Wireless SmartCell Gateway 200 Getting Started Manual page 97

Figure 37. "Accept all" indicates that LWAPP2SCG is enabled
If LWAPP2SCG is disabled, do the following to enable it:
a Enter config.
b Enter lwapp2scg.
c Enter policy.
d Enter one of the following commands:
- accept {MAC
address}: Enter this command if you only want specific APs to be
-
managed by the controller. See
accept-all: Enter this command if you want all APs that discover the
-
controller to be managed by it.
Figure 38. Options that appear after you enter the "policy" command
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
Ensuring That APs Can Discover the Controller on the Network
Method 4: Configure DHCP Option 43 on the DHCP Server
Figure 39.
97