Ruckus Wireless SmartCell Gateway 200 Getting Started Manual page 64

Table 12. New zone settings
Field
SNMPv2 Agent
SNMPv3 Agent
Configuration > DHCP Service for Wi-Fi Clients (Zone)
Enable DHCP
Service in this zone
Configuration > Model Specific Options (AP Groups)
Note: Select the Override check box for that setting, and then configure the setting.
AP Model
USB Port
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
Description
Indicates if the SNMPv2 agent is
enabled.
Indicates if the SNMPv3 agent is
enabled.
Indicates if the DHCP service is
enabled.
Indicates the AP model that you are
configuring.
Disables the USB port on the selected
AP model.
Configuring the SCG for the First Time
Your Action
If the SNMPv2 agent is enabled,
configure the community settings.
1 Click Create and enter
Community.
2 Select the required Privilege.
3 If you select Notification, enter
the Target IP.
4 Click OK.
If the SNMPv3 agent is enabled,
configure the community settings.
1 Click Create and enter User.
2 Select the required
Authentication.
3 Enter the Auth Pass Phrase.
4 Select the Privacy option.
5 Select the required Privilege.
6 If you select Notification, select
the option Trap or Inform and
enter the Target IP and Target
Port.
7 Click OK.
Select the check box.
Select the option.
Select the option to disable the USB
port. USB ports are enabled by
default.
Creating an AP Zone
64