Unpacking The Controller - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

Unpacking the Controller

WARNING!
together to unpack the controller. Ruckus Wireless strongly recommends against
one person attempting to perform this task alone.
Follow these steps to unpack the controller.
1 Open the controller package, and then carefully remove the contents.
2 Return all packing materials into the shipping box, and then put the box away
in a dry location.
3 Verify that all of the items listed in
included in the package. Check each item for damage. If any item is damaged
or missing, notify your authorized Ruckus Wireless sales representative
immediately.
Verifying the Package Contents
A complete controller package contains all of the items listed below:
• One controller with two AC/DC power supply units
• One console cable (use only this cable to connect the front or rear serial port via
a laptop/notebook)
• One rack mount kit (see
• Service Level Agreement / Limited Warranty Statement sheet
• Regulatory Statement sheet
• This Getting Started Guide
NOTE: The AC power cable (part number 902-0174-XX00, where XX is the two-
character country code) is not supplied with the controller and may be ordered
separately.
SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A
The controller is heavy (40 lbs/18.14kg). Two people should work
Rack Mount Kit Contents
Preparing to Set Up the SmartCell Gateway 200
Verifying the Package Contents
below)
Unpacking the Controller
(below) are
10