Overview Of The Scg Setup Wizard - Ruckus Wireless SmartCell Gateway 200 Getting Started Manual

Smartzone 3.5.1

Hide thumbs Also See for SmartCell Gateway 200:

Table of Contents

Overview of the SCG Setup Wizard

Follow these steps to run and complete the SCG Setup Wizard.

Step 1: Start the Setup Wizard and Set the Language

Step 2: Configure the Management IP Address Settings

Step 3: Configure the Data Plane IP Address Settings

Step 4: Configure the Cluster Settings

Step 5: Verify the Settings

Step 1: Start the Setup Wizard and Set the

Language

1 Connect one end of an Ethernet cable to ETH2 on the rear panel of the SCG,

and then connect the other end to an Ethernet port on the administrative

computer.

Figure 18. Location of ETH2

2 Start your web browser, and then enter the following in the address bar:

http://192.168.2.2:8443

The SCG Setup Wizard appears, displaying the Language page.

SmartCell Gateway 200 Getting Started Guide for SmartZone 3.5.1, 800-71517-001 Rev A

Running the Setup Wizard and Logging On to the Web Interface

ETH2

Overview of the SCG Setup Wizard

Table of Contents

Do you have a question about the SmartCell Gateway 200 and is the answer not in the manual?

Scg200